21 Mar

Free Download Cisco 200-120 Exam Question with PDF & VCE (51-60)

QUESTION 51
Refer to the exhibit. Which two statements are true about interVLAN routing in the topology that is shown in the exhibit? (Choose two.)
511

A.    Host E and host F use the same IP gateway address.
B.    Router1 and Switch2 should be connected via a crossover cable.
C.    Router1 will not play a role in communications between host A and host D
D.    The FastEthernet 0/0 interface on Router1 must be configured with subinterfaces.
E.    Router1 needs more LAN interfaces to accommodate the VLANs that are shown in the exhibit.
F.    The FastEthernet 0/0 interface on Router1 and the FastEthernet 0/1 interface on Switch2 trunk ports must be configured using the same encapsulation type.

Answer: DF

QUESTION 52
Which two of these are characteristics of the 802.1Q protocol? (Choose two.)

A.    It is used exclusively for tagging VLAN frames and does not address network reconvergence following switched network topology changes.
B.    It modifies the 802.3 frame header, and thus requires that the FCS be recomputed.
C.    It is a Layer 2 messaging protocol which maintains VLAN configurations across networks.
D.    It includes an 8-bit field which specifies the priority of a frame.
E.    It is a trunking protocol capable of carrying untagged frames.

Answer: BE

QUESTION 53
Refer to the exhibit. Each of these four switches has been configured with a hostname, as well as being configured to run RSTP. No other configuration changes have been made. Which three of these show the correct RSTP port roles for the indicated switches and interfaces? (Choose three.)
531

A.    SwitchA, Fa0/2, designated
B.    SwitchA, Fa0/1, root
C.    SwitchB, Gi0/2, root
D.    SwitchB, Gi0/1, designated
E.    SwitchC, Fa0/2, root
F.    SwitchD, Gi0/2, root

Answer: ABF

QUESTION 54
What is one benefit of PVST+?

A.    PVST+ supports Layer 3 load balancing without loops.
B.    PVST+ reduces the CPU cycles for all the switches in the network.
C.    PVST+ allows the root switch location to be optimized per VLAN.
D.    PVST+ automatically selects the root bridge location, to provide optimized bandwidth usage.

Answer: C

QUESTION 55
Refer to the exhibit. The network administrator normally establishes a Telnet session with the switch from host A. However, host A is unavailable. The administrator’s attempt to telnet to the switch from host B fails, but pings to the other two hosts are successful. What is the issue?
551

A.    Host B and the switch need to be in the same subnet.
B.    The switch interface connected to the router is down.
C.    Host B needs to be assigned an IP address in VLAN 1.
D.    The switch needs an appropriate default gateway assigned.
E.    The switch interfaces need the appropriate IP addresses assigned.

Answer: D

QUESTION 56
Which are valid modes for a switch port used as a VLAN trunk? (Choose three.)

A.    transparent
B.    auto
C.    on
D.    desirable
E.    blocking
F.    forwarding

Answer: BCD

QUESTION 57
Refer to the exhibit. Which switch provides the spanning-tree designated port role for the network segment that services the printers?
571

A.    Switch1
B.    Switch2
C.    Switch3
D.    Switch4

Answer: C

QUESTION 58
Refer to Exhibit. How many broadcast domains are shown in the graphic assuming only the default VLAN is configured on the switches?
581

A.    one
B.    two
C.    six
D.    twelve

Answer: A

QUESTION 59
Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)

A.    802.1Q native VLAN frames are untagged by default.
B.    802.1Q trunking ports can also be secure ports.
C.    802.1Q trunks can use 10 Mb/s Ethernet interfaces.
D.    802.1Q trunks require full-duplex, point-to-point connectivity.
E.    802.1Q trunks should have native VLANs that are the same at both ends.

Answer: ACE

QUESTION 60
Refer to the exhibit. The output that is shown is generated at a switch. Which three statements are true? (Choose three.)
601

A.    All ports will be in a state of discarding, learning, or forwarding.
B.    Thirty VLANs have been configured on this switch.
C.    The bridge priority is lower than the default value for spanning tree.
D.    All interfaces that are shown are on shared media.
E.    All designated ports are in a forwarding state.
F.    This switch must be the root bridge for all VLANs on this switch.

Answer: ACE

Free Download Cisco 200-120 Exam Question with PDF & VCE